In the section “GPS speed, km/h”:

Possible options:

• GPS data. This calculation method is set when the terminal transmits the speed value based on GPS data

• Always 0 km/h. This calculation method is set when the terminal does not transmit GPS speed data. Omnicomm Online will display the value of vehicle speed as 0. With this method, you cannot set the odometer “from terminal (with drift)” in Omnicomm Online

• Always 10 km/h. This calculation method is set when the terminal does not transmit GPS speed data. Omnicomm Online will display the value of vehicle speed as 10.

In the section “GPS direction, degree”:

Possible options:

• Calculate by coordinates. This calculation method is set when the terminal transmits coordinates based on GPS data

• GPS data. This method of calculation is set in case the terminal transmits the direction of vehicle movement according to GPS data

• Always 0. This calculation method is set when the terminal does not send GPS directions. Omnicomm Online will not display movement direction

In the “Number of satellites” section:

Possible options:

• “GPS correctness” flag. This calculation method is set if the terminal transmits information about the correctness of GPS data. Omnicomm Online will register the correct GPS data when the corresponding event is received from the terminal

• GPS data. This calculation method is set when the terminal sends data on the number of GPS satellites

• Always 12. This calculation method is set in case the terminal does not send data on the number of satellites by GPS. Omnicomm Online will register the constant presence of 12 satellites

In the section “GPS altitude, m”:

Possible options:

• GPS data. This calculation method is set in case the terminal transmits the height value of a vehicle position according to GPS data

• Always 0. This calculation method is set in case the terminal does not transmit altitude value according to GPS data and Omnicomm Online will not display the altitude value

In the “GPS data accuracy” section:

Possible options:

• “GPS correctness” flag. This calculation method is set if the terminal transmits information about the correctness of GPS data. Omnicomm Online will register the correct GPS data when the corresponding event is received from the terminal

• Number of visible GPS satellites. This method is set if the terminal does not transmit the GPS Correctness flag. Omnicomm Online will register correct GPS data if the number of visible satellites is more than 3

• Always Correct data. This calculation method is set if the terminal does not transmit any of the above parameters. Omnicomm Online will capture correct data at all times