1. Switch on the Omnicomm OKO video terminal power

2. Connect the video terminal to a PC via Ethernet interface using a LAN adapter and a patch cord delivered with the video terminal

3. Open the adapter network settings window by running “Control Panel / Network and Internet / Network Connections”:

4. Open the connection properties window by right-clicking the mouse and selecting “Properties”:

5. Select Internet Protocol Version 4 (TCP/IPv4), press “Properties”, and set the following configuration:

6. Press “OK”

1. Connect the video camera to any video terminal connector (“CAM1” – “CAM4”)

2. Open Internet Explorer and enter the camera configuration address. By default: 192.168.12.241

3. A window will open to confirm ie.exe installation:

4. Press “OK” and follow the installer's tips

5. Refresh the page or restart the browser

6. You will be prompted to enable the Active X add-on:

7. Press “Allow”

The browser will be configured only once, ie.exe reinstallation is not required.

1. Switch on the Omnicomm OKO video terminal power

2. Connect the video terminal to a PC via Ethernet interface using a LAN adapter and a patch cord delivered with the video terminal

3. Connect the video camera to any video terminal connector (“CAM1” – “CAM4”)

4. In your browser, enter the video camera configuration interface address – 192.168.12.241

In the “Account” and “Password”, enter “admin”.

Press the “Log in” button.

5. In the “Settings” / “TCP / IP setting” section:

Set the IP address in the corresponding field, depending on the connector the camera is plugged in:

“CAM1”: 192.168.12.241

“CAM2”: 192.168.12.242

“CAM3”: 192.168.12.243

“CAM4”: 192.168.12.244

When several cameras are connected to the video terminal, their IP addresses must be different.

Perform connection according to the diagram:

If necessary, use an extension cord (3, 5, 7, or 10 meters), which can be purchased separately. You may use multiple extensions together to achieve the required cable length.