Omnicomm terminals may be configured in two ways:

1. In the Omnicomm Configurator when the terminal is connected to a PC
2. In the Remote Configuration Server (RCS) – remotely

1. Connection the terminal to a PC using USB cable

2. Install and run Omnicomm Configurator. A window will open

3. Select equipment – “Terminal”.

Advanced mode allows you to configure all the equipment parameters available.

List of parameters shown in advanced mode only:

In the “Connection” section:

• Data collection and transmission blocking
• EGTS protocol settings
• Communication Server No. 2, No. 3 connection settings
• GSM and SMS communication parameters
• Roaming connection parameters
• Roaming parameters

In the “RS-485 and RS-232 Interfaces Configuration” section:

• “CAN-log”
• “J1708”
• “NMEA reception”
• “NMEA transmission”
• “PP-01”
• “Camera”
• “DV-01”
• “Tachograph VDO”
• “iQFreeze”
• “TPMS Pressure Pro”
• “ALM Weight Indicator”
• “Carrier Reefer”

In the “Auxiliary equipment” section:

• Panic button parameters
• Accelerometer parameters

Sections “Universal inputs”, “CAN”, “Identification”, “Geofences”, “Outputs”, “Driving Control”.

To connect to the configuration server, open the browser and in its address bar enter the address http://config.omnicomm.ru:9911/#en. A window will open:

To add terminals:

1. In the “Terminal ID” field enter the terminal identification number
2. In the “Password” field enter the password set in the terminal during its setting using Omnicomm Configurator
3. Press the “+” button