SMS commands
SMS commands for Terminal configuration
| Command | Function | |
|---|---|---|
| Command text in SMS message | Reply to SMS command | |
| *CONNECT# | CONNECT url_CS:port | Request to establiish connection between the Terminal and the CS |
| *GETLINK# | LINK ip4_url_CS:port date_and_time | Enquiry on state of connection to the CS |
| *GETINFO# | INFO DID=device ID HW=code_hardware_version BL=loader_version FW=wiring_version REC=number_of_archived_records IMEI=unique_identificator_of_GSM_modem | Enquiry on the terminal state |
| *RESET# | RESET param Possible parameter readings: param = OK (when command is sent) param = ER (when no command is sent) | Restarting the Terminal |
| *GETSTAT# | STAT Terminal_date_and_time GPS=GPS coordinates SPD=speed IGN=state_of_ignition L1=fuel_level:sensor_state … L6=fuel_level:sensor_state LLS/ 0 - sensor off; 1 - sensor not ready; 2 - sensor ready, frequency of 20 to max. Hz; 3 - error, frequency of 0 to 19 Hz | Request to check vehicle state |
| *SETPWDID vid pwdid# vid is the Terminal's ID, pwdid is password/identificator | SETPWDID ERRID/ERRNulPWD/ERRAlrSet/PWD:pwdid OK | Setting the “password” parameter |
| *CONNECTSC# | RESET param Possible parameter readings: param = OK (when command is sent) param = OK (when command is sent) param = ER (when no command is sent) | Enquiry on establishing connection of the terminal with the configuration server |
| *SETAPN apn# apn – operator's APN | SETAPN apn ERR/OK | APN installation |
| *GPSCOLD# | GPSCOLD ERR/OK | Cold start of GPS receiver |
