Спасибо!

Мы исправим ошибку в ближайшее время

Сообщить об ошибке

Site Tools


Selection of Location to Install the Product

1) The product should be installed, depending on geometric shape of the tank, at the locations shown in the figures (Figure 1, Figure 2, Figure 3). Product installation at these locations ensures fuel level independence of vehicle inclination.

Figure 1

Figure 2

Figure 3

2) If the Product cannot be installed in any of places specified in Figures (Figure 1, Figure 2, Figure 3), the installation place must be as close to any of the specified as possible.

3) Product installation at the locations other than shown in the figures (Figure 1, Figure 2, Figure 3), may cause fuel level dependence on vehicle inclination. For example, for vehicles operating on the high-relief landscape this will mean either overrated or underrated fuel level values.

Installation of two products in one fuel tank allows to significantly reducing fuel level dependence on vehicle inclination. Two products should be installed at the locations shown in the figures (Figure 4, Figure 5)

Figure 4 Figure 5