Firmware Change Log
| Date | Firmware Version | Changes |
|---|---|---|
| July 26, 2018 | FW 305 | - upgraded GPS connection (satellite loss, track gaps solved) - failure after page reloading rectified - track gaps in case of CS failure eliminated |
| January 14, 2019 | FW 307 | - solved factory reset issue when cleaning the terminal data archive or in case of on-board network voltage drop - enhanced GPS communication (eliminated periodic coordinate discarding at 00-00 UTC) - solved a problem of lack of communication with Profi Wi-Fi terminals, if there is a 0 in IP-address (for example, 192.168.0.1) - rectified freezing of Omnicomm |
| March 20, 2019 | FW 308 | - implemented the function of collecting arbitrary CAN-parameters from VH operating according to FMS, and displaying CAN data in Omnicomm Online - terminal factory reset eliminated - solved failures of terminal time stamps, VID, PID - added protection from satellite loss due to QZSS (Japanese Quasi-Zenith Satellite System) - implemented the function of the terminal calling back to the number in case of bad voice connection |
| October 31, 2019 | FW 309 | - a new speed filtration algorithm when selecting GPS data source developed - it is now possible to transfer data to 3 Communication Servers simultaneously (except for Smart) - a possible period of data collection has been decreased to one time per 1 second (except for Smart) - now up to 2 digital LLS fuel level sensors can be connected to Smart terminals, and up to 4 digital sensors – to Light - GSM signal level is displayed now - ContiPressureCheck tyre pressure monitoring system now supported - accelerometer calibration state is now displayed at the Remote Configuration Server - the number of geofences has been increased to 60, and the number of points to 240 |
