The Omnicomm Optim, Profi, and Profi Wi-Fi terminals support the connection of up to 8 temperature sensors.

On the “Settings” tab select section “Auxiliary equipment” from the list.

The “Temperature sensors” displays the temperature readings from the sensors, connected via 1-Wire interface.

Set up the temperature sensors. Choose the set up option:

• set up of the 1-Wire interface. Press the “Set up the temperature sensors” button
• set up via the universal input. Press the “Set up the temperature sensors (UI)” button

Set up of the 1-wire interface:

“Name” – input the name of the temperature sensor.

“Value” – displays the readings from the sensor.

“ID” – select the ID number of the temperature sensor.

Set up via the universal input:

“Transmit the readings of the 1-Wire sensor instead of UI” – select the number of the universal input for displaying the temperature readings in Omnicomm Online.

Connect the temperature sensors to Omnicomm terminals according to the diagram:

1-Wire sensor connection diagram with an extended range of external power supply:

Make sure that the onboard voltage does not exceed the max power supply voltage of the temperature sensor specified in the sensor passport.

1-Wire DS18B20 sensors connection diagram on a double-wire circuit with additional power supply from the terminal for operation in an extended range below -20 C and above +60 C:

In case of configuring the terminal in Omnicomm Configurator it is necessary to disable the possibility to use GSM call button (in the “GSM and SMS connection parameters” / “Headset” section – off, see Data Transmission to a Communication Server).