1. Select a vehicle or geofence
2. Please select a period of time for report generation
3. Press button “Add report” and select “Visiting the Geofences”

To select the information displayed in the report, right-click and select “Report settings”:

“Total values only” - if enabled, only the total values of parameters will be displayed in the report. The times of entering and leaving the geofence will not be displayed

“Group by the second column” - enables grouping by geofence name. When grouping by the second column is disabled, the items are grouped by the time of entering a geofence

“Movement outside of geofences” - enables displaying vehicle movement parameters outside of geofences

Right-click the mouse to enable the display of parameters outside geofences and additional grouping by geofences:

This report contains the following information on the VH:

• VH is a VH registration number or name
• Geofence is a geofence name
• Time of entering the geofence is date and time of entrace to thegeofence dd/mm/yyyy hh:mm
• Time of exiting the geofence is date and time of exit from the geofence of dd/mm/yyyy hh:mm
• Duration of staying inside the geofence, hh:mm
• Number of visits is a number VH geofence entries within the selected period of time
• Mileage, km is a mileage of the VH in the geofence
• Mileage with exceeding the maximum allowed speed, km - mileage exceeding the maximum allowed speed set in the vehicle profile
• Average speed in motion, (km/h) is an average VH motion speed in the geofence
• Movement time is time during which the VH was moving in the geofence, hh:mm:ss
• Downtime is time during which the VH's downtime was identified when the VH was in the geofence, hh:mm:ss

• Downtime, (hh: mm: ss) is time within a period which will be calculated using a formula:

“Downtime” = “time of operation under rated load” – “idle time within period” – “overultimate load time”

• General consumption, l is general consumption of the VH when the VH is in the geofence
• Volume of refueling, l is a volume of fuel refueled when the VH is in the geofence
• Volume of draining, l is volume of fuel drained when the VH is in the geofence

Calculation of the VH presence in the geofence:

− If at the period the VH was in the geofence, duration of the stay in the geofence shall be calculated from the period start and to the moment of escape from the geofence or end of period depending on which of these events took place earlier. I.e. if a moment of exit from the geofence is earlier than an end of period, the duration shall be calculated from the period start to the moment of exit from the geofence. In “Time of entrance to the geofence” field the dash “-” will be displayed.

− If at the period end the VH was in the geofence, duration of the stay in the geofence shall be calculated from the entry to the geofence or a period start depending on which of these events took place later and till the period end. If the moment of entry to the geofence is later, that the period start, duration of stay shall be calculated from the moment of entry to the geofence to the period end. In the field “Time of entry to the geofence” dash “-” shall be displayed.

− If the period end is greater than the current time, when calculating duration, the current time instead of period end shall be used.

• Treated area, ha
• Productivity, ha/hour
• Rated consumption, l/ha

Dynamic geofences can be created in the vehicle profile (see Omnicomm Online. Administration Guide. The "Profile editing" section).